distributor for Toyota MR2 W1 / Corolla Celica 4A-GELC

4A-GELC (the California-spec, 16-valve Blue Top) is critical because it differs from the standard 4A-GE found in other regions. This engine was primarily used in the AW11 MR2 (1985–1989), the Corolla FX16, and the Celica GT (AT160).

1. Genuine OEM Part Numbers

Toyota used two primary distributor assemblies for the 4A-GELC during its production run. The transition point is typically the late 1987 facelift.

Production Date	Part Number	Vehicle Notes
12/1984 – 08/1987	19100-16130	Early AW11 MR2 & Corolla FX16.
08/1987 – 12/1989	19100-16210	Late AW11 MR2 (often with internal revisions).

Service Parts:

Distributor Cap: 19101-16080 (Standard for 4A-GELC).
Distributor Rotor: 19102-16060 (Replaced by 19102-73180).
Housing O-Ring: 96711-35030 (Crucial for preventing the common oil leak into the distributor cap).

2. Identifying the 4A-GELC Distributor

The 4A-GELC distributor is unique because it integrates specific sensors required for the Toyota Computer Control System (TCCS).

The Connector: Most 4A-GELC units use a specific two-plug or multi-pin configuration. Before ordering, verify if your current plug is a 2-pin, 4-pin, or a combination (often referred to as 2P+2P).
The “Blue Top” Distinction: While the distributor for a “Red Top” (later 4A-GE) might look similar, the internal signal wheels for the crank angle sensor (Ne and G signals) can vary, leading to a “No Start” condition if mismatched.

3. Aftermarket & High-Performance Options

If you cannot find a New Old Stock (NOS) Toyota unit, there are several reliable alternatives:

SKP / Cardone: Common aftermarket replacements. Look for part number TD79Q3 (SKP) or VW178NW, which are specifically mapped to the 4A-GELC 1.6L.
123\Ignition (Digital Upgrade): For those looking to eliminate mechanical wear, 123\TUNE offers a fully electronic distributor for the 4A-GE. It allows you to program the advance curve via Bluetooth or USB, which is excellent for modified engines or those running modern fuels.
Rebuild Kits: Since the internal bearings and seals often fail before the electronics, companies like KBOX or Ultra Wheel offer specialized seal kits to stop oil from saturating the internal sensors.

4. Technical Tip: The “Leaking” Issue

If you notice oil inside the distributor cap or a “ticking” sound at idle, the internal shaft seal has likely failed. Replacing just the outer O-ring will not fix this; you will need to either rebuild the internal shaft with a new bearing and seal or replace the entire assembly to prevent the oil from shorting out the igniter.